Applied Science and Engineering Progress

Vol 6, No 1 (2013)

Table of Contents

---

Technology

Rational Design of Process Simulation Models Using Manufacturing System Design Decomposition	PDF
N. Murray and K. Taraman	1-9

Design and Development of Electronic Fuel Injection Control System Program for Single Cylinder Diesel Engine	PDF
S. Sittichompoo, Kampanart Theinnoi and B. Sawatmongkhon	11-17

The Study of the Springback Effect in the UHSS by U-bending Process	PDF
N. Sae-Eaw, Chan Thanadngarn, Kampanat Sirivedin, V. Buakaew and Y. Neamsup	19-25

Investigation of the Parameters Affecting the Die Failure in High Extrusion Ratio of Aluminium Square Hollow Profile by Using Viscoplastic Finite Element Modelling	PDF
Yingyot Aue-u-lan, K. Khansai, Piboon Sinpayakun and Chalie Tragangoon	27-33

Determination of Optimal Preform Part for Hot Forging Process of the Manufacture Axle Shaft by Finite Element Method	PDF
V. Sukjantha and Yingyot Aue-u-lan	35-42

Manufacturing Systems Design Decomposition and Process Failure Mode Effect Analysis	PDF
N. Murray, M. O’Connor and K. Taraman	43-49

Gear Tooth Profile Error caused by Hob Misalignment	PDF
kosuchon Satayotin, prasert Prachprayoon and Yasuaki Hiroo	51-55

The measures to improve the manufacturing process by using the lean concept for hard disk drive industry	PDF
P. Sungkamee and P. Peerapattana	57-66

Knowledge Synthesis Using Multichannel of Media in the Case Study of Integrated Circuit Industry	PDF
V. Hirunyasiri and Suthep Butdee	67-79

The Integrated Learning System on Technical English for Communication in Careers…How and what is it?	PDF
Phaop Phuangnoi, Nataya Kaewsai, S. Lerkbangplad and Bubpha Setobol	81-86